Brick & Repointing · Bergen County
Brick & Repointing in Maywood, NJ
Maywood brick work is small-borough scale. Ten-minute drive from our yard. Most jobs are chimney repointing on the postwar single-family stock and the occasional pre-war duplex repointing along Spring Valley Road. The pre-war stock needs lime-rich mortar; postwar stock takes Type N or Type S depending on original construction.
10Min from yardMaywood, NJ
10-min drive
From our Garfield yard
24-hour estimate
Written, no obligation
Bergen County
Maywood, NJ
Licensed & insured
NJ #13VH10343500
About working in Maywood
What Maywood masonry actually looks like
Site conditions, housing stock, and the kinds of projects we get called for in this town — the local context behind our estimates and recommendations.
Housing stock & neighborhoods
Maywood is small enough that we know which streets have parking restrictions on which days, which matters when we're staging materials for a stoop rebuild. Most jobs here are wrap-up-in-a-week pieces — a front walk, a backyard patio, a chimney repoint, an apron replacement — and the borough's responsiveness on permits matches that pace. The older Spring Valley blocks have prewar brick that responds well to careful repointing. We sample the mortar before opening any joints, and we always color-match in our shop rather than guessing on site.
What we build
Brick & Repointing — what's included
New brick, repointing, chimney rebuilds, and façade restoration with mortar matched to the original building.
- Full-depth and partial-depth tuckpointing
- Mortar color and joint-profile matching on pre-1940 façades
- Lintel repair and replacement
- Brick replacement for spalled or salvaged courses
How we build it
Brick & Repointing — start to finish
The four stages we run on every brick & repointing job. Same workflow whether it's a small fix or a full install.
1
Survey the façade
We photograph at scale and tap-test every brick face within reach. Spalled brick, cracked lintels, and joints that have lost more than 1/4 inch of mortar all get marked.
2
Match mortar and joint
We pull a joint sample, cross-check color in sunlight, and mix a small test patch on the building. Tooled to match the original profile — concave, V, struck, or beaded.
3
Rake, repoint, and replace
Failed joints raked to 3/4 inch depth (not deeper than 2× the joint width). New mortar pressed in two lifts. Spalled brick swapped course-by-course with salvaged or matched stock.
4
Clean and final pass
Brick face cleaned without acid wash where possible. Final walkthrough at street distance so you can see the work reads as part of the original wall.
Maywood questions
About brick & repointing work in Maywood
7 questions — the trade fundamentals plus the ones we hear most in this area.
Why does mortar matching matter so much?
A wall with the wrong mortar will tell on itself from across the street. Modern Type S mortar is too hard for soft pre-1940 brick — it transfers stress to the brick face and causes spalling. The right mortar is softer than the brick around it on purpose.
Tuckpointing vs. repointing — what's the difference?
Repointing replaces failed mortar joints. Tuckpointing is a decorative technique that uses two mortar colors — a base coat plus a thin contrasting ribbon — to make joints look thinner than they are. Most jobs we do are repointing; true tuckpointing is rare and usually historic.
Do I need to repoint the whole façade?
Almost never. We spot-repoint where joints have actually failed and leave sound joints alone. Repointing sound mortar makes the wall look freshly patched. A good repoint job is invisible from twenty feet.
How long does brick repointing last?
A correctly matched repoint outlasts the surrounding wall — usually 50+ years. The failure mode isn't the new mortar; it's the original brick continuing to weather. We'll tell you which joints have another decade in them and which don't.
LocalHow fast can you start a Maywood brick job?
Most weeks, same week. Ten-minute drive from our yard. We can usually walk the site within hours and quote within 24 hours.
LocalWhat's the right mortar for a pre-war Maywood duplex?
Type N lime-rich mortar matched to the original sand color. The pre-war stock along Spring Valley Road uses soft brick that needs the right binder — Portland mortar will spall the face within five years.
LocalDo Maywood brick projects need permits?
Chimney work and structural masonry need a permit. The borough office handles residential paperwork in about a week.
More services in Maywood
What else we build in Maywood.
Same crew, same warranty. Click any service to see scope and process for Maywood specifically.
Free Estimate · Maywood, NJ
Ready to talk through your brick & repointing project in Maywood?
We're 10 minutes from your door. Tell us what you're building and we'll walk the site, check footings and drainage, and leave you a written estimate within 24 hours.
- Site visit booked within 24–48 hours
- 5-year written workmanship warranty
- Licensed (NJ #13VH10343500), insured, family-owned
Or call for a fast quote(973) 272-5869