Concrete Work · Bergen County
Concrete Work in Cliffside Park, NJ
Our first concrete job in Cliffside Park was a driveway replacement on a Palisades-side lot, 2014. The original slab had cracked through and settled toward the road. We had to regrade for proper drainage during base prep so the new pour didn't repeat the same failure. That's the pattern on hillside lots here — drainage planning matters more than slab thickness.
18Min from yardCliffside Park, NJ
18-min drive
From our Garfield yard
24-hour estimate
Written, no obligation
Bergen County
Cliffside Park, NJ
Licensed & insured
NJ #13VH10343500
About working in Cliffside Park
What Cliffside Park masonry actually looks like
Site conditions, housing stock, and the kinds of projects we get called for in this town — the local context behind our estimates and recommendations.
Housing stock & neighborhoods
Predominantly 1920s–1960s single-family on small lots; some pre-war two-families on the western streets. Most common asks here: Concrete driveway tear-out and replacement; Brick stoop and front-walk repair; Retaining walls on Palisades-side lots; Chimney repointing and crown work.
What we build
Concrete Work — what's included
Driveways, walkways, slabs, and footings with proper subgrade compaction and clean control joints.
- Broom-finish driveways and aprons, 4 in. residential / 6 in. heavy-load
- Exposed aggregate patios and walkways
- Stamped and integrally colored concrete
- Footings for porches, garages, generators, and outdoor kitchens
How we build it
Concrete Work — start to finish
The four stages we run on every concrete work job. Same workflow whether it's a small fix or a full install.
1
Excavation & subgrade
Strip topsoil. Cut to depth (typically 8 inches for a residential driveway). Compact subgrade in lifts with a plate compactor — this is the step that decides whether the pour lasts.
2
Form, base, and reinforcement
Form boards staked and leveled. 4 inches of compacted 3/4-inch clean stone base. Rebar or mesh placed on chairs so reinforcement actually sits inside the slab, not on the dirt.
3
Pour, screed, and finish
Concrete placed, screeded, bull-floated. We hand-edge, broom-finish (or stamp / expose), and saw-cut control joints at proper spacing — typically every 8–10 feet for a residential slab.
4
Cure and seal
Cure compound the same day. Stay off it for 24 hours, light traffic at 72, full load at 28 days. Optional densifier sealer in week two locks out road salt.
Cliffside Park questions
About concrete work work in Cliffside Park
7 questions — the trade fundamentals plus the ones we hear most in this area.
Will it crack?
Concrete is going to crack — we control where. Saw-cut control joints at proper spacing tell the slab where to crack, so the cracks land inside the joints and read as joints instead of failures. A slab without joints cracks anyway, just randomly.
Stamped vs. exposed aggregate?
Stamped is a textured top layer pressed into wet concrete — gives you a brick or slate look at a concrete price. Exposed aggregate washes off the cement paste to reveal the stone underneath. Stamped looks more decorative; exposed aggregate is grippier and reads more contemporary.
How thick should my driveway be?
4 inches over a compacted base for a residential driveway with passenger vehicles. 6 inches if you have a heavy truck, RV, or trailer. The base matters as much as the slab thickness — a 6-inch slab on bad subgrade fails before a 4-inch slab on a proper base.
Should I seal new concrete?
Yes — but not in year one. Concrete needs to cure and finish off-gassing first. A breathable penetrating sealer in year two protects against deicing salts (a real issue in North Jersey), and we'll come back to apply it if you want.
LocalWhy does Cliffside Park concrete require regrading?
The lots tilt toward the road or the Palisades drop. Many original mid-century slabs were poured without proper surface grade for drainage. We regrade during base prep so the new pour has positive flow away from the foundation.
LocalCan you handle a Cliffside Park concrete stoop replacement?
Yes. Standard three-to-five-riser concrete stoops with rebar reinforcement and proper footings. The borough construction office issues residential permits in about a week. The work runs 3 to 5 days.
LocalDo you do concrete patios on cliffside lots?
Yes. We work the patio elevation into the existing slope, design surface drainage during excavation, and pour with rebar reinforcement. Frost-protected footings under any wall-supporting concrete keep the install stable.
More services in Cliffside Park
What else we build in Cliffside Park.
Same crew, same warranty. Click any service to see scope and process for Cliffside Park specifically.
Free Estimate · Cliffside Park, NJ
Ready to talk through your concrete work project in Cliffside Park?
We're 18 minutes from your door. Tell us what you're building and we'll walk the site, check footings and drainage, and leave you a written estimate within 24 hours.
- Site visit booked within 24–48 hours
- 5-year written workmanship warranty
- Licensed (NJ #13VH10343500), insured, family-owned
Or call for a fast quote(973) 272-5869