Paver Patios & Driveways · Hudson County
Paver Patios & Driveways in Jersey City, NJ
Pavers in Jersey City are downtown rear-yard installs and Heights backyard work. Both face narrow-lot constraints. Most jobs run 300-500 sq ft with polymeric joints and snap-edge restraint. Material staging is the planning piece — curbside delivery and wheelbarrow access through side-yard pass-throughs. Drainage flows to street outlets on most properties.
24Min from yardJersey City, NJ
24-min drive
From our Garfield yard
24-hour estimate
Written, no obligation
Hudson County
Jersey City, NJ
Licensed & insured
NJ #13VH10343500
About working in Jersey City
What Jersey City masonry actually looks like
Site conditions, housing stock, and the kinds of projects we get called for in this town — the local context behind our estimates and recommendations.
Housing stock & neighborhoods
Pre-1900 brownstones in Downtown and Hamilton Park, Victorian woodframe in the Heights, post-1960 high-rises near Exchange Place and Newport, and mid-century single-family in Greenville. Most common asks here: Brownstone stoop and façade restoration; Tuckpointing on pre-1900 brick; Backyard paver patios and seating walls; Stone veneer accent walls.
What we build
Paver Patios & Driveways — what's included
Patios, driveways, walkways, and pool decks built on a deep compacted base with polymeric joints.
- Herringbone, basketweave, and running-bond patterns
- Permeable paver driveways for stormwater compliance
- Soldier-course borders and cut radius edges
- Polymeric jointing and edge restraint
How we build it
Paver Patios & Driveways — start to finish
The four stages we run on every paver patios & driveways job. Same workflow whether it's a small fix or a full install.
1
Layout and excavation
String lines on the design. Excavation to 8–12 inches below finish grade — deeper for driveways. Geotextile fabric on the subgrade if soils are soft or wet.
2
Compacted base
3/4-inch clean stone placed in 2-inch lifts, each lift compacted with a plate compactor before the next goes in. This is where 80% of the long-term performance lives.
3
Bedding and laying
1 inch of bedding sand screeded to grade. Pavers laid in the chosen pattern (herringbone for driveways — it locks under load). Soldier-course border tied to the field.
4
Edge, joints, and compact
Snap-edge restraint spiked into the base. Polymeric joint sand swept in, blown clean, then misted to activate. Final pass with the compactor over a roller mat sets the field flush.
Jersey City questions
About paver patios & driveways work in Jersey City
7 questions — the trade fundamentals plus the ones we hear most in this area.
How long does a paver installation take?
A typical 400 sq ft patio is 5–7 working days. A driveway runs 1–2 weeks depending on size and how much we have to dig out. Weather and base condition are the big variables — soft subgrades take longer to compact correctly.
Polymeric sand vs. regular sand for joints?
Polymeric. It locks the joints, stays put through rain and snowblowing, and stops weeds from rooting. Regular sand washes out within a season. Polymeric needs to be installed dry on a dry surface, then misted — installer error here is the most common reason a paver job fails early.
Will pavers heave in the winter?
Not if the base is right. The base has to drain freely so water doesn't sit and freeze under the field. Bedding sand depth needs to be uniform (1 inch — not more). Joints need polymeric sand keeping moisture out of the base.
Can pavers go over an existing concrete slab?
Sometimes — it depends on the slab's condition, drainage, and finish elevation. We have to add 1.5–2 inches of stack height, so steps and door thresholds become a problem. We'll tell you honestly whether it's worth it for your slab or whether you're better off tearing out and starting on a proper base.
LocalHow do you stage materials in Downtown Jersey City?
Curbside the night before, per parking-enforcement permit. Pump trucks deliver bedding sand to rear yards through the side-yard pass-through. Polymeric joint sand and the pavers themselves wheelbarrow through.
LocalCan you do paver work in Hamilton Park historic blocks?
Yes for rear-yard installations. The historic-district overlay primarily affects front-facing exterior changes, so rear-yard paver work is generally less constrained. We confirm with the preservation office on the address before bidding.
LocalWhat's a typical Heights paver patio install?
Three hundred to five hundred square feet on most Heights lots. The Heights' Victorian housing has more rear-yard space than Downtown's row houses, so larger patios are workable. Base prep is the same regardless of location.
More services in Jersey City
What else we build in Jersey City.
Same crew, same warranty. Click any service to see scope and process for Jersey City specifically.
Free Estimate · Jersey City, NJ
Ready to talk through your paver patios & driveways project in Jersey City?
We're 24 minutes from your door. Tell us what you're building and we'll walk the site, check footings and drainage, and leave you a written estimate within 24 hours.
- Site visit booked within 24–48 hours
- 5-year written workmanship warranty
- Licensed (NJ #13VH10343500), insured, family-owned
Or call for a fast quote(973) 272-5869